What good epoxy floor coating actually involves
Epoxy fails for one reason above all others: it was rolled onto concrete that was not mechanically prepared. A coating bonded to laitance and old sealer will lift in sheets the first winter, usually where the car tyres sit.
We grind or shot-blast the slab to open the surface, deal with moisture and any oil contamination, fill the cracks and pits, then build the system up in coats. The result is a floor you can wash with a hose and that shrugs off road salt through a Maryland winter.
What we bring to it
Mechanically prepared slab
Diamond grinding or shot blasting, not an acid wash and hope. This is the single biggest determinant of whether the coating lasts.
Moisture and contamination checks
We test for slab moisture and treat oil-soaked areas before coating rather than sealing the problem in.
Crack and pit repair
Control joints, spalling and pitting filled and levelled so the finished floor is smooth and easy to clean.
Finish options
Solid color, decorative flake or a clear topcoat, with an anti-slip additive where the floor gets wet.
What this service covers
- Residential garage floors
- Basement and utility room floors
- Workshops and commercial back-of-house
- Concrete grinding and surface preparation
- Crack, joint and spall repair
- Decorative flake and anti-slip finishes
Epoxy Floor Coating — frequently asked
How long before I can park on it?
Foot traffic is usually next day; vehicle traffic typically needs the full cure, commonly around five to seven days depending on the system and temperature. We give you exact dates in the quote.
Will hot tyres lift the coating?
Not with a properly prepared and correctly specified system. Hot-tyre pickup is the classic failure of a big-box DIY kit rolled onto unground concrete.
Can you coat a floor with existing oil stains?
Yes, but the contaminated areas need degreasing and often grinding out first. We assess the slab before quoting rather than after.
Does it work in a damp basement?
Only after moisture testing. If the slab is passing significant vapor, a standard epoxy will fail — there are moisture-mitigating primers for that, and we will tell you if you need one.
